The PIP USM-4151L is a full-back stainless steel mesh tunic designed to provide torso protection in environments where metal mesh garments are appropriate. The garment features a long front length of 48 inches in the front and 32 inches in the back with a 16-inch split leg, paired with short sleeves for a pull-over fit that minimizes exposed skin while allowing mobility. The lightweight steel ring wire, with a diameter of .019 inches, contributes to a comfortable wear while preserving the protective properties of the mesh. An extended front apron includes a belly guard to help reduce exposure to knife sticks, offering additional protection where activity occurs at the front of the torso. The product is compliant with recognized standards for metal mesh garments and is suitable for direct contact in food-related contexts when paired with compatible PPE, as indicated by its documented compliance assertions.
Construction notes emphasize that this is a cut and puncture resistant garment rather than a garment that is impervious to all damage. The tunic is made from stainless steel mesh and is designed to be reusable and launderable, with care instructions recommending hand washing and avoidance of bleach to protect the integrity of the ring welds. The packaging is listed as bagged each, with a case quantity of 10, which informs stocking and fulfillment planning. Included documentation references a spec sheet for technical details, which can be downloaded for detailed sizing and maintenance guidance.
Potential users should consider the garment’s form factor and care requirements when planning use. The full-back design offers torso coverage while the short sleeves may influence heat management in warmer environments. As with all metal mesh PPE, verify compatibility with other protective layers and confirm that the garment meets the specific regulatory or internal standards applicable to your operation before ordering. The product is intended for professional use where metal mesh protection is appropriate and can be laundered between uses to extend its lifecycle.
Features:
- Lightweight stainless steel mesh with .019" wire diameter
- Extended apron front with belly guard for additional protection
- Pull-over tunic design protects the torso
- Short sleeves suitable for use with sleeves
- FDA 21 CFR compliant for direct food contact
- Complies with European EN1082 standards
- Material is stainless steel mesh; not guaranteed to be cut/puncture proof
- Color:
- Silver
- Sustainability:
- Reusable / Launderable
- Clothing Type:
- Full Back Tunic
- Material:
- Steel Wire Mesh
- Packaging:
- Bagged Each
- Taa Comp:
- 0
- High Frequency:
- 0
- Medium Frequency:
- 0
- Low Frequency:
- 0
- Material Content:
- STAINLESS STEEL
- Care Instructions:
- Mild detergent, such as dish washing soap. Warm water (122 F / 50 C). Soak mesh in soapy water 10-15 min, medium bristle brush to scrub off fat and debris. Rinse in hot (180 F/ 82 C) to remove remaining particles. It is not recommended to soak metal
- Wash Instructions:
- Hand Wash
- Bleach:
- Do Not Bleach
- Dry Instructions:
- Hang Dry
- Package Size:
- Each
- Case Quantity:
- 10
