The Vestil D-150-12 Vinyl Dock Seal is designed to seal the gap between a loading dock and the rear of a trailer, helping to minimize energy loss and defend freight against weather exposure. This unit features three foam-filled pads covered in heavy-duty nylon-reinforced vinyl with a 36 oz. fabric, providing tear resistance and durable performance. The ends are chemically sealed to help reduce moisture infiltration, and a built-in air escape tunnel allows air to exit as a trailer makes contact, aiding a consistent seal. The three-piece construction includes a 12-inch-high seal with beveled side edges that taper from 9-1/2 inches at the wall to 12 inches at the face, and it ships with a through-the-wall installation kit for straightforward mounting.
The design accommodates a 12-inch projection and is intended for use with flush-dock configurations in conjunction with Edge-O-Dock systems, where a 20-inch projection seal is required for proper alignment. This unit uses factory-furnished mounting hardware and installation instructions to simplify setup, and it notes that units are non-returnable. The 36-ounce nylon-reinforced vinyl facings provide a balance of weather resistance and tear strength, which helps protect the dock area and trailer payload during loading operations. Understanding the installation geometry and projection requirements is important to ensure a proper fit and effective sealing across the dock face.
Features:
- Three foam-filled pads offer full dock protection
- Maximum compression design offers maximum protection
- Built-in air tunnels allow air to escape when contacted by a trailer
- Mounting hardware and installation instructions included
- Projection (in.):
- 12
- Nylon Reinforced Vinyl (oz.):
- 36
- Package Size:
- Each
